Electric stackers have brought great convenience to handling and unloading. With the continuous development of our society, there are more and more places where electric stackers are needed. It has many advantages, good operability and good economic benefits. However, many people only care about the convenience brought by electric stackers and ignore their usual maintenance and maintenance, which is detrimental to their use effect, performance and lifespan. The following is about electric stackers. Some knowledge of pallet truck maintenance and repair.

1. Battery maintenance of electric handling stacker

Check whether the connection of the charging circuit is reliable, check whether the connection between the connection and the plug is intact; check whether the charger of the electric handling stacker is in good condition, check whether the battery is seriously lacking in liquid; check whether there is irreversible sulfation of the pole plate.

 

2. The circuit part of the electric handling stacker

Do not use the electric handling stacker under voltage; do not use the electric handling stacker while charging; pay attention to rain protection.

3. The forks of the electric handling stacker have fixed pallet type and movable fork type

There is a spacer at the connection between the root of the movable fork and the electric handling stacker, and the height of the spacer is adjusted by screws to achieve the purpose of adjusting the height of the front section of the fork.

4. Electric handling stacker leaks oil

Most of the oil leakage is at the connection between the oil pipe and the oil cylinder or the pump station. If it is confirmed that the nut has been tightened and the oil continues to leak, the nut needs to be disassembled, the gasket or explosion-proof valve should be replaced with the correct model or a new one, and then re-tightened. Generally, this fault can be solved. When removing the nut, the fork must be lowered to a very low level, so that all the hydraulic oil in the oil circuit has been returned to the cylinder of the pump station to avoid a large amount of leakage.